← Back home

Muji Pen

3D CADSolidWorksSegal Design Certificate

I rebuilt a Muji gel pen in SolidWorks from my own measurements, one part at a time.

Finished render of the Muji pen

Assembly or part

The pen comes apart into separate pieces, so it had to be an assembly. I measured each piece and where they meet, then drew a layout sketch splitting the pen into four parts: the chassis, the ink, the top cap and the bottom cap. That sketch became the blueprint and placed every part in position before any mates.

The real Muji pen, taken apart
Layout sketch of the chassis

The chassis

I started from the main cylinder, since the concave section can't be modeled without it. The black inner tube that sits inside the clear shell was the hard part: I lofted it as surfaces, then thickened them into the opaque inside and the transparent outside. I reused the loft as guide curves to cut the lip that stops the ink tube from falling through.

Cross-section of the chassis tip
Surface lofts for the inner tube

The ink

One revolve could have made most of it, but every piece needed its own color, so I built it up from stacked extrudes kept as separate bodies. The metal tip is a revolve.

The ink cartridge tip
Ink cartridge body

The twisting cap

The hardest part to plan. It has a lot of circular symmetry, but the order of operations decides whether the model holds up. After talking it through with my TA, I built it inside out: the inner tube and its teeth first, then the ridges and connecting tubes, and the outer shell last.

Circular pattern of the teeth
Connecting tubes
Finished cap

The threads

SolidWorks' thread presets were far too big for a part this small, so I made custom ones: a helix with a pitch matched to the real threads, then cut the thread profile along it.

Thread profile sketch
Threads cut into the cap

What I learned

I got to practice layout assemblies, solid modeling to build up parts, surface modeling for difficult geometry, and careful planning for a small, intricate part. If I did it again, I'd plan every part as carefully as the cap. SolidWorks is unforgiving, and planning saves a lot of time.

The finished assembly